Drain Jetting Carrington
Drain jetting in Carrington uses high-pressure water to scour blocked sewers and stormwater lines clean, with no chemicals. We quote a fixed figure before the jetter starts, and the clear is checked with a camera afterwards. Ring (02) 4063 1232 or use the form for a jetting visit anywhere on the peninsula.
Licensed plumbers and gas fitters · NSW Lic. 359278C
Last updated September 2026
What Kind of Blockage Calls for the Jetter?
Grease, silt and paper are what the jetter eats best. An eel only opens a channel through the middle; the jetter strips the whole bore, so the flow comes back close to what the pipe was built for.
Faults the jetter suits:
- Grease and fat built up along kitchen and laundry runs
- Silt and fine material washed into stormwater lines on the flat blocks
- Paper snagged on rough or offset joints in old clay sewers
- Residue left behind after a root mass has been cut out
If the blockage turns out to be a collapsed section rather than a clog, jetting alone will not fix it. The repair is priced on its own, and nothing past the clear goes ahead without your say.
How a Jetting Job Runs
- 01
Ring or send the form
Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.
- 02
A fixed price first
A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.
- 03
The jetter goes in
High-pressure water and a matched nozzle scour the pipe from the nearest opening, flushing debris out and leaving the wall clean.
- 04
Covered for a year
Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.
The method sits inside the wider blocked drains service, which covers diagnosis and every way of clearing a line. Hot water, gas and leak work sit elsewhere, and any of it can be booked through our plumber in Carrington page.
What Changes the Cost of a Jetting Job?
We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.
The jetting price moves with:
- Line length and access A sewer running the full depth of a block takes more hose than a laundry branch does.
- The camera pass Checking the line before and after the clear is the honest way to quote, and it is priced into the job.
- What comes out Grease scours away quickly; a root mass or a line packed with silt takes longer.
- Groundwater on the flat If excavation is needed for access on this reclaimed ground, trenches can need bailing, and that is in the figure from the start.
Why Jetting Earns Its Keep on the Peninsula
The ground decides how drains fail here
Groundwater keeps the old lines half busy
Where jetting cleans but cannot cure, go sideways: CCTV drain inspection films the cause, tree root removal deals with roots still growing, and pipe relining fixes a cracked length from inside.
What a Customer Said
We talked through the options of our blocked kitchen sink drain (not just an s bend problem) and came to the perfect long term solution at a reasonable price.
When We're Not the Right Call
Jetting cannot rebuild a pipe. If the footage shows a clay length broken in two, water pressure only washes out the gap, and a repair or liner is the real answer. A choke in Hunter Water's sewer main beyond your fence is theirs to jet, not ours.
Common Questions
Will high-pressure water crack the old clay pipes under my Carrington cottage?
Not when the job is run to suit the pipe. Pressure and nozzle choice change with what the camera shows, so a fragile earthenware run is jetted at lower pressure than a sound modern line. On the heritage grid we check the condition first and jet to match it.
Do you jet stormwater lines as well as sewers?
Yes. Stormwater gullies on the flat peninsula blocks clog with leaf litter and silt, and the same jetter clears them. If the line is backing up because street pits are overwhelmed in a downpour, those pits are the council's to clear, not a jetting job.
Does jetting shift tree roots, or just cut them back?
The jetter cuts the root mass out of the pipe and scrubs the wall clean behind it. Roots that have grown through a joint will come back eventually, so a camera pass afterwards shows the entry point, and relining can seal it for good.
How is jetting different from using an electric eel?
An eel punches a path through a blockage, but it leaves grease and silt on the wall. Jetting scours the whole pipe, so the line runs closer to full bore and the next blockage is further away. On lines that fail repeatedly, jetting plus a camera is the lasting combination.
Need a plumber? Call or send the form
Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.
Request a callback
Leave a name and number and a plumber will ring you back.